Belling CHIM60 Spécifications télécharger pdf (Page 11)

If using a remote fan with the Chimney hood, follow the instructions listed below.

The Independent Chimney hood is designed for 3 speed fan motors only! It is not designed for use with variable speed

applications.

1. The molex plug mounted within the front portion of the hood supplies power to the remote fan. Connect the male

molex pigtail supplied with the Independent remote fan to the molex plug. Route the wire ends into the hood j-

box. Connect these wires to the remote fan wires within the hood j-box. (See figure 13.)

2. If using a Remote fan for a 30" Chimney hood, remove and discard the adapter plate. (See Figure 14.)

WIRING A REMOTE FAN

HIGH HEAT SENSOR

A HIGH HEAT SENSOR is integral to the complete line of Independent Hoods.

It is activated when the exhaust temperature reaches 200˚ F (93˚ C) and deactivates

as the temperature decreases to 186˚F (85˚C). If the fan is operating on the low speed,

and the HIGH HEAT SENSOR engages, the fan motor will automatically change to

high speed until the temperature decreases.

Figure 13.

Molex Pigtail supplied with

Remote Fan:

Plug into mating

Hood Molex Plug.

Route the Hood wires into the

hood J-Box and connect to the

Remote Fan.

Molex Plug

mounted

inside front

of Hood

powers Fans.

From Remote Fan:

connect to Hood Molex Plug

making connection in Hood J-Box.

Connect Fan wires

to Pigtail wires that are

plugged into Hood.

(Black to black, red to red,

blue to blue,

white to white.

Wire to Remote Fan

Hood J-Box

Wiring Remote Fans

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Belling CHIM60 Spécifications Page 11