Belling Gas hobs Manuel de service télécharger pdf (Page 20)

INSTALLATION INSTRUCTIONS - GAS PRODUCTS

Connect to the gas supply

Means of isolation shall be provided at the

shut off point by either an approved quick

connect device or a Type 1 manual shut

off valve. The outlet of the quick connect

device shall be at, or below, the horizontal

position.

Connection to the gas supply should be

made using the Aquaknect AS/NZS 1869

class B hose assembly with an internal

diameter of not less than 10mm and

regulator (regulator for use with natural

gas)

NOTE: Maximum length of hose 900mm.

The temperature rise of the areas at the

rear of the cooker that are likely to come

into contact with the flexible hose do not

exceed 70˙C.

The inlet to the cooker is ½” BSP internal

situated at the rear right corner. Fit the

bayonet connection. This should be

located so as to ensure that the flexible

connector hose does not kink.

Under no circumstances should the fle

xible

connector be allowed to come into contact with

the vertical oven flue tubes on the rear of the

appliance.

Use a 900mm - 1125mm length of

flexible connector.

Ensure that all pipework is of the correct

rating for both size and temperature.

After installation, make sure all connections

are gas sound.

Commissioning

Burner aeration

All burners have fixed aeration and no

adjustment is possible.

Pressure setting

Natural Gas @ 1.00kP

Propane Gas @ 2.75kPa

Pressure test point

Use a hob injector

Connect to the electricity supply

Unless this appliance is supplied with a fitted plug,

it must be connected by a competent person, using

fixed wiring via a double pole switched fused spur outlet,

with a contact separation of 3mm at all poles.

Connect the mains lead wires to the terminals:

The blue wire must be connected to the terminal marked

N(Neutral) LOAD or coloured black.

The brown wire must be connected to the terminal marked

L(Live) LOAD or coloured red.

The green/yellow coloured wire must be connected to the

terminal marked E(Earth) or coloured green.

Warning: this appliance must be earthed.

The fused spur must be accessible after installation.

If the supply cord is damaged, obtain a special cord from

the Customer Care Helpline, which must be fitted by

a qualified person.

Hob burner - Turn the control knob to the

FULL ON position, wait a second before

pressing the ignition switch or holding a

lighted match or taper to the burner. Hold

the control knob in for 15 seconds. Do not

hold the control knob in for longer that 15

seconds. If the burner fails to light within

this time, release the control knob and

wait one minute before attempting further

ignition.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Belling Gas hobs Manuel de service Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Belling Gas hobs