Belling Gas hobs Manuel de service télécharger pdf (Page 17)

Fit the hob into the cutout &

secure to worktop

Place the hob into the cutout and

secure in place using the four brackets

and screws provided.

The brackets should be orientated to

suit the worktop thickness as shown,

then inserted into the four slots (two on

the front edge and two on the rear)

and screwed into the underside of the

worktop using the woodscrews provid-

ed.

The screws should be tightened just

sufficiently to secu re the hob a nd pull

the top press ing fl ush with the work-

top.

If the base of the hob is accessible

after ins tallation then a partition must

be fitted 20mm below the base to pre-

vent access.

seal

hob

40mm

worktop

seal

hob

30mm

worktop

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Pas de commentaire

Belling Gas hobs Manuel de service Page 17