Belling Gas hobs Manuel de service télécharger pdf (Page 18)

Alternative clamp positions

If the front and rear clamp positions

are problematic, alternative positions

can be used o n the s ides of the hob,

dependant on the particular installa-

tion.

These positions will require clearance

from any cabinet sides and may effect

how tightly the hob will meet the work-

top.

Stone (Granite or equivalent)

worktops

Depending on th

e type of worktop

being used, there may or may not be

any backing material to screw the

clamp screws into.

1. If the w orktop is a composite type

(backed with MDF or similar) there

may b e enough backing to screw

directly i nto. This will depend on

the worktop thickness and backing

thickness and will have to be

assessed at th e installation. In this

case, install the h ob as for a stan-

dard worktop.

2. If there is insufficient backing mate-

rial to screw into, or if the worktop

is comple tely solid in const ruction,

then it will be necessary to glue a

strip of wood, MDF, fibre board or

similar to the underside of the work-

top, along the front and rear edges

of the cutout. Use a strong, propri-

etary adhesive to bond these strips

and a llow to cure before atte mpt-

ing to clamp the hob into position

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Pas de commentaire

Belling Gas hobs Manuel de service Page 18