Belling Hob Manuel de service télécharger pdf (Page 15)

Fit the hob into the cutout &

secure to worktop

Place the hob into the cutout and

secure in place using the four brackets

and screws provided.

The brackets should be orientated to

suit the worktop thickness as shown,

then inserted into the four slots (two on

the front edge and two on the rear)

and screwed into the underside of the

worktop using the woodscrews provid-

ed.

The screws should be tightened just

sufficiently to secure the hob and pull

the top pressing flush with the work-

top.

If the base of the hob is accessible

after installation then a partition must

be fitted 20mm below the base to pre-

vent access.

seal

hob

40mm

worktop

seal

hob

30mm

worktop

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire