Belling SCGHU60GC Manuel de service télécharger pdf (Page 15)

INSTALLATION

13.300

Alternative clamp positions

If the front and rear clamp positions

are problematic, alternative positions

can be used on the sides of the hob,

dependant on the particular installation.

These positions will require clearance

from any cabinet sides and may effect

how tightly the hob will meet the worktop.

Stone (Granite or equivalent)

worktops

Depending on the type of worktop

being used, there may or may not be

any backing material to screw the

clamp screws into.

1. If the worktop is a composite type

(backed with MDF or similar) there

may be enough backing to screw

directly into. This will depend on

the worktop thickness and backing

thickness and will have to be

assessed at the installation. In this

case, install the hob as for a standard

worktop.

2. If there is insufcient backing material

to screw into, or if the worktop

is completely solid in construction,

then it will be necessary to glue a

strip of wood, MDF, breboard or

similar to the underside of the worktop,

along the front and rear edges

of the cutout. Use a strong, proprietary

adhesive to bond these strips

and allow to cure before attempting

to clamp the hob into position.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Belling SCGHU60GC Manuel de service Page 15